IH-888-NT - 21/23oz indigo Selvedge DWC Jeans

[neph93]

I need a final length of about 31” for jeans to fall and sit without a break. I don’t cuff unless I have to but don’t mind a little stacking (the wider the hem, the less stacking I want).

I had mine hemmed to 33.5 and after shrinkage and wear (combs can take up .5”). They are now around about how they should be with a little stacking and measure 31.5”.

It isn’t an exact science though. The absolute best solution if you are very particular about the end result is to get them hemmed after soaking/washing.

[richardjohn22]

Thanks for the reply @neph93 . Interesting that you lost the full 2 inches, from a 33.5" starting point. As I tend to wear boots predominantly now, a little extra rather than a little bit short seems to be the side to hedge my bets towards.  Nice if you can wander around the house without treading on the hem or needing to cuff, though.

[neph93]

I was surprised myself tbh.

[Yossarian]

I also lost 2 inches and actually a little bit more. I found that this fabric shrinks a lot and actually didn't settle to its final measurements until the 3rd wash.

[spitfiredealer]

Yeah I lost 2 as well. They are also hemmed to a inch shorter than I usually take, because of the rise this worked out well.



Bonus pic to show you how great they fade.


Sent from my iPhone using Tapatalk

[richardjohn22]

2inches seems to be standard loss, then.  So based on my existing jeans with higher rise (1955S) being 30.4 and a tad too long, and my jeans with lower rise (Levis 541) being 30.7 and perfect, I should aim for 30.5 I guess?  Which means hemming to 32.5

[mpukas]

My 888-NT shrank 1.5" in length, from 35.5" to 34.0", after a cold soak and five - yes 5 - washes in the first month. A couple of years ago I had a pair of 1955-UHR and they lost 2.25" after a cold soak and 1 wash. 2" shrink in length seems to be the standard. I was looking for a 33" inseam, and advised by IHUK to err on the side of more shrink and get them hemmed to 35.5".

They didn't shrink as much as I anticipated, and with higher rise they are longer than I anticipated (I wear these lower on my hips than higher at my waist, just because that's where they end up). I cuff occasionally, and usually walk around with excessive stacks. I'd rather have them too long than too short, but I really need to get them hemmed shorter.

[Crit_Obs]

So no restocks on these shall be forthcoming, when they are gone they’re gone? Seeing how they are out of size 32 now, I should probably move my feet on the 31 or risk missing out. Hnnnnnnggg... But what was this I heard about a black version in this cut, or have I been jeans-dreaming again?

[Giles]

We will possibly restock the non NT version

https://www.ironheart.co.uk/bottoms/ih-888-uhr.html

but it won't be for a few months if we do.

We're releasing a 21oz overdyed version and a 21oz  super black selvedge version....

[manufc10]

We will possibly restock the non NT version

https://www.ironheart.co.uk/bottoms/ih-888-uhr.html

but it won't be for a few months if we do.

We're releasing a 21oz overdyed version and a 21oz  super black selvedge version....

This is good news.  I would be in for another pair if they are restocked. 

[Mustafa911]

 @giles , 21od and super black of same UHR material ? Little bit confused with your posting and mentioning these two denim.


Sent from my iPhone using Tapatalk

[manufc10]

@giles , 21od and super black of same UHR material ? Little bit confused with your posting and mentioning these two denim.


Sent from my iPhone using Tapatalk

No, not of the UHR material.  21oz flagship denim OD and 21oz super black denim. 

[Mustafa911]

@manufc10
Thank you


Sent from my iPhone using Tapatalk

[Crit_Obs]

If my intuition suggests tag size 32, then size 31 is probably correct, right? 

I’d be shooting for 32”ish waist post-shrink, post-stretch; looking at the measurements, tag size 31 which starts at 31.5” should fit the bill. I’d prefer the front rise of a size 32 pair, though; on the other hand, the slimmer leg from thigh-down on a size 31 pair is also very welcome. It would seem the raw thigh measurement of 12.5” on a size 31 pair would translate to 12+” post-wash, which would be ok.

What’s the ETA on the black versions? Was it so that they were meant to follow the sizing convention of the UHR model, give or take?

[Giles]

IWHWIH and we'll tell you when we have measured them....